Harley Davidson Engine Idle Management System

I turned it off and have had no more trouble.

Harley davidson engine idle management system. Turn on ignition switch push engine offrun switch right handlebar to the run position dont start bike. Jim if your light is green when you roll the throtte forward then the system is onthe light indicates the status of the system when you check it. 1st phase at 160c head temp it will reduce the idle until it cools down or reaches 800 rpm.

EITMS can be used by any rider but is specifically for those riders who frequently find themselves in riding conditions where the vehicle is subjected to prolonged idle conditions or traffic congestion the motorcycle is equipped with an Engine Idle Temperature Management System EITMS to provide limited cooling of the rear cylinder. Before that they used a 3 phase management system. You may find it out in the manual of your vehicle.

The ESPFI system is a completely new engine management system used on select 2001 and later Softail models and select 2002 and later Touring models. Majority of bikes from the factory have this feature disabled. Changing Oil and Oil Filter.

Repeat procedure as needed to enabledisable EITMS. Showing the bikes idlesound difference when the Harley Davidson EITMS. 2014 TWIN-COOLED FILL NECK.

Engine Idle Temperature Management System. Forums Harley Davidson Motorcycles Touring Models Engine Idle Temperature Management System Discussion in Touring Models started by Btown Bagger Jun 14 2009. 061000 engine and engine coolingengine Summary.

This is a simple rundown of the EITMS system on Harley Davidson Motorcycles. You have to have the engine off and the ignition on rotate the throttle forward until the cruise control indicator light in the tach flashes green around 5 times do the same to turn it off except the cruise light will flash red. Depending on your bikes model of Harley Davidson manufacturers must have recommended a particular RPM range.