Harley Davidson Exhaust Stud Removal

To remove difficult exhaust nuts you often have to use heat from a torch.

Harley davidson exhaust stud removal. Remove the old exhaust crush gaskets. Aftermarket exhaust systems for Harley bagger can be grouped into two broad categories. Install the washer and nut on each cylinder heat stud.

The end that takes the flange nut is 516-24. If you are riding a Harley you shouldnt have any exhaust manifolds bolted to the heads. Remove Difficult Exhaust Nuts.

For help with doing this consult your Honda manual or a Clymers manual 2. Personally Id remove them with the correct tool and just replace them with new ones. Sprayapply a small amount of WD-40 where the stud meets the engine.

A stud remover grabs them the best but will mar the threads. A very common owner mistake that can usually be avoided. The studs will remain intact on their respective exhaust components.

Also the heat from the weld will help to loosen the stud. They have a unique ball lead to prevent cross threading. A bike is benefited not only by removing gas from its engine but also by its many advantages.

Supplied with drill bit. Discussion Starter 1 May 23 2005. The Fatboy is a production of Harley Davidson.