Harley Davidson Grip Removal

How to Replace Grips on a Harley-Davidson by JP Cycles.

Harley davidson grip removal. Remove the grip from the handlebar. You can change your hand grips for comfort looks or both. To remove the grip a slight tug may be necessary to release the index pins in the grip from the receptacle in the seal cap.

Once clean wipe the bars with some light oil to help the throttle rotate easier. You can also use compressed air to try to break the adhesive bond. The instructions provided with the Tracker grips say to use a long-shank flat tip screwdriver to remove the grip but I found that slicing the grip with a sharp knife and then.

Remove the left grip. Remove the grip from the handlebar. Save you money and let us show you how to do this so you dont have to pay a mechanic.

Attach the throttle open and close cables by inserting the ferrules over the ball ends and into the new grip. Remove the clamp and position the clutch hand lever assembly away from the handlebar. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife.

I will leave a link below for the Avon grips that I used. Loosen but do not remove the upper and lower switch housing screws 1. Remove the clamp and position the clutch hand lever assembly away from the handlebar.

In order to find the very end squeeze the grip from. To remove the old grip not caring whether you destroy it cut off the very end of it. Be careful and try a heat gun or hair dryer enough to loosen the contact cement you used on the grip and try to rotate the grips.