Harley Davidson Handlebar Installation Requirements

Installation of some handlebars and risers may require a change in clutch andor throttle cable and brake lines for some models.

Harley davidson handlebar installation requirements. Seat handlebar with knurled areas centered on rise base. Verify that the ignition switch is turned to OFF. Check local laws to ensure your motorcycle meets applicable regulations.

If the procedure is not within your capabilities or you do not have the correct tools have a Harley-Davidson dealer perform the installation. We came across 1 issue the bar clamp system only allowed bars that were specifically designed for this one model of bike. This article applies to the Harley Davidson Touring.

The uprights of the handlebar run roughly parallel to the front forks. Harley-Davidson Motor Company cannot test and make specific fitment recommendations concerning every possible mirror and handlebar combination. For 1 handlebars The above bars reduce down from 1 14 to 1 at the risers You absolutely do not have to use the same kit or bars we used in the tutorial video.

All models require separate purchase of additional components. Motorcycle configuration and or products shown may vary by locale region due to compliance regulations. Combining the edgy profile of a classic Z bar with the knuckles-up feel of a mini-ape and the narrow width of a drag bar the Fused Handlebar delivers a fistful of classic chopper attitude.

Remove and retain the two cap screws C beneath the upper fork bracket that hold the existing lower handlebar risers B in place. In 2015 when the Road Glide was reintroduced the changes were awesome. Verify that wires clutch cables throttleidle cables and brake lines do not pull tight when handlebars are turned fully to left or right fork stops.

Installation of some handlebars and risers may require a change in clutch andor throttle cable and brake lines for some models. Ideal location is between handlebar risers. Install ape hangers drag bars t-bars or beach bars.