Harley Davidson Engine Break In Procedure

It is written that way because no one would believe a rear gear needs a break-in procedure.

Harley davidson engine break in procedure. You buy a new machine and follow the directions. To allow your engine to wear-in its critical parts we recommend that you observe the riding rules provided below for the first 500 miles. Find a stretch of straightaways and.

Repeat this procedure 3 to 4 times each time raising the running temperature 10 and gently vary the rpm from idle to 2500 in the final cycle. 1- Initial start up. Up to 500 miles vary the engine speed and avoid operating at any speed for long periods.

At two years and one day you are riding it back to the dealer to trade it in on a new one and the transmission locks up the engine throws a rod and the primary has turned into a pile of iron filings. Warm the engine up thoroughly while riding it it easy. In fact nothing is worse for your engine that driving around an un-tuned engine especially for an extended period.

No need to follow the lengthy break-in procedure. Oct 14 2013 at 828pm ET. Everyone knows an engine does.

During the first 50 miles of riding keep the engine speed below 3000 RPM 5000 RPM for VRSC in any gear. Even if you. Correct engine break-in procedures are important and prevent unnecessary component damage while ensuring long engine life minimal oil consumption and maximum power.

What is actually being done during engine break-in is fairly simple its the controlled bedding or wearing-in of the new piston rings on the hone of the cylinder walls. BREAK-IN PROCEDURE 1. No further break-in is necessary.